1. Changelog:
Support i.MX952 15x15 EVK with Power group updated.
2. Update 0001-CMakeLists-do-not-use-vendored-libcurl.patch for 1.1.128
Signed-off-by: Liu Yiding <liuyd.fnst@fujitsu.com>
Signed-off-by: Khem Raj <raj.khem@gmail.com>
Please see
https://git.yoctoproject.org/poky/commit/?id=4dd321f8b83afecd962393101b2a6861275b5265
for what changes are needed, and sed commands that can be used to make them en masse.
I've verified that bitbake -c patch world works with these, but did not run a world
build; the majority of recipes shouldn't need further fixups, but if there are
some that still fall out, they can be fixed in followups.
Signed-off-by: Alexander Kanavin <alex@linutronix.de>
Signed-off-by: Khem Raj <raj.khem@gmail.com>
Version 1.1.115 is the first non-prerelease since 1.1.100.
Changes between 1.1.100 and 1.1.115 include:
- All BCU settings will now be cleared by default after using the
`reset` command unless `-keep` is used.
- `remote_en` will be deasserted after using `onoff` command unless
`-keep` is used.
- Add i.MX6ULL support
- Add i.MX943 19x19 A0 and B1 EVK support
Signed-off-by: Leonard Göhrs <l.goehrs@pengutronix.de>
Signed-off-by: Khem Raj <raj.khem@gmail.com>
The bcu command can be used to communicate with board control hardware on
NXP EVK development boards to:
- reset / power cycle the board into a specified boot mode.
- monitor the power consumption.
- read / write the eeprom content.
- measure temperatures.
- etc.
Supported boards are e.g.:
- i.MX8MP-EVK
- i.MX8DXL-EVK
- i.MX8ULP-EVK
- i.MX93-EVK
The tool can either be built for the target architecture to control a
board from a system running Yocto (less common) or for the host
architecture to run it via `oe-run-native bcu-native bcu`.
Signed-off-by: Leonard Göhrs <l.goehrs@pengutronix.de>
Signed-off-by: Khem Raj <raj.khem@gmail.com>
Liu Yiding
Alexander Kanavin
Leonard Göhrs