Leonard Göhrs 1d47796fcf bcu: add nxp board control utilities version 1.1.100 ...

The bcu command can be used to communicate with board control hardware on
NXP EVK development boards to:

  - reset / power cycle the board into a specified boot mode.
  - monitor the power consumption.
  - read / write the eeprom content.
  - measure temperatures.
  - etc.

Supported boards are e.g.:

  - i.MX8MP-EVK
  - i.MX8DXL-EVK
  - i.MX8ULP-EVK
  - i.MX93-EVK

The tool can either be built for the target architecture to control a
board from a system running Yocto (less common) or for the host
architecture to run it via `oe-run-native bcu-native bcu`.

Signed-off-by: Leonard Göhrs <l.goehrs@pengutronix.de>
Signed-off-by: Khem Raj <raj.khem@gmail.com>

2024-11-01 06:43:16 -07:00

..

bcu

…

bcu_1.1.100.bb

…