Having RPI_KERNEL_DEVICETREE_OVERLAYS:append = " overlays/bcm2712d0.dtbo"
in raspberrypi5.conf is not applying when building an 64bit compatible image
with raspberrypi-armv8. Thus moving into the rpi-base.inc
This fix the boot of this image on Raspberry Pi 5 hw rev 1.1
Signed-off-by: Thomas Roos <throos@amazon.de>
Similar to raspberrypi4-64.conf, we need to set KERNEL_IMAGETYPE_UBOOT to
"Image" and set KERNEL_BOOTCMD to "booti"
Signed-off-by: Tim Orling <tim.orling@konsulko.com>
"zImage" not supported on arm64 so set KERNEL_IMAGETYPE_DIRECT to
"Image" for Raspberry Pi 5 and avoid the following errors:
| make: *** No rule to make target 'zImage'. Stop.
| ERROR: oe_runmake failed
This work was sponsored by GOVCERT.LU.
Signed-off-by: Leon Anavi <leon.anavi@konsulko.com>
Set SERIAL_CONSOLES to ttyAMA10. This fixes login on the UART
no matter if systemd is used.
This work was sponsored by GOVCERT.LU.
Suggested-by: Gael PORTAY <gael.portay@rtone.fr>
Signed-off-by: Leon Anavi <leon.anavi@konsulko.com>
Set SDIMG_KERNELIMAGE to kernel_2712.img instead of kernel8.img.
Raspberry Pi 5 firmware defaults to loading kernel_2712.img because
this image contains optimisations specific to Raspberry Pi 5
(e.g. 16K page-size). For more details:
https://www.raspberrypi.com/documentation/computers/config_txt.html#kernel
This work was sponsored by GOVCERT.LU.
Signed-off-by: Leon Anavi <leon.anavi@konsulko.com>
Gijs Peskens
Thomas Roos
Ayoub Zaki
Tim Orling
Leon Anavi
Florin Sarbu